Newly Update Fortinet NSE 7 - SD-WAN 6.4 NSE7_SDW-6.4 Dumps Questions

Newly Update Fortinet NSE 7 – SD-WAN 6.4 NSE7_SDW-6.4 Dumps Questions

test2022-09-09T03:55:11+00:00

If you are worried about your NSE7_SDW-6.4 Fortinet NSE 7 – SD-WAN 6.4 exam, FreeTestShare NSE7_SDW-6.4 Dumps Questions will help you better comprehend the information included in the actual exam. You will be able to pass the NSE7_SDW-6.4 exam with flying colors if you use our practice questions and answers. NSE7_SDW-6.4 Dumps Questions from FreeTestShare are the greatest way to ensure your success in only one sitting. By practicing with our NSE7_SDW-6.4 Dumps Questions, you will be able to easily answer all the questions.

This free NSE7_SDW-6.4 practice test can now be used to assess your preparation.

Page 1 of 2

1. Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

set cost 15.

set source 100.64.1.1.

set priority 10.

set load-balance-mode source-ip-based.

2. Which diagnostic command can you use to show the SD-WAN rules interface information and state?

diagnose sys virtual-wan-link neighbor.

diagnose sys virtual―wan―link route-tag-list

diagnose sys virtual―wan―link member.

diagnose sys virtual-wan-link service

3. Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two)

Secure Shell (SSH)

Encapsulating Security Payload (ESP)

Internet Key Exchange (IKE)

Transport Layer Security (TLS)

Security Association (SA)

4. Refer to exhibits.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.

Based on the exhibits, which statement is correct?

Both SD-WAN member interfaces have used separate SLA targets.

The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Port1 became dead 1ecause no traffic was offload through the egress of port1.

SD-WAN member interfaces are affected by the SLA state of the inactive interface

5. What are two reasons why it is effective to implement the internet service database (ISDB) in an SD-WAN rule? (Choose two)

The ISDB applies rules to traffic from specific sources, based on application type

The ISDB is dynamically updated and reduces administrator maintenance

The ISDB requires application control to maintain signatures and perform load-balancing

The ISDB covers the SDN dynamic connectors private and public addresses

The ISDB contains the IP addresses and port ranges of well-known destinations

6. Refer to the exhibit.

Which two statements about the debug output are true? (Choose two)

The debug output shows per-IP shaper values and real-time readings.

FortiGate provides statistics and reading based on historical traffic logs.

Traffic being controlled by the traffic shaper is under 100 KB/s.

This traffic shaper drops traffic that exceeds the set limits.

7. Which statement reflects how BGP tags work with SD-WAN rules?

BGP tags match the SD-WAN rule based on the order that these rules were installed.

BGP tags require that the adding of static routes be enabled on all ADVPN interfaces

Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag

VPN topologies are formed using only BGP dynamic routing with SD-WAN

8. In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two)

Traffic has matched none of the FortiGate policy routes.

Matched traffic failed RPF and was caught by the rule.

The FIB lookup resolved interface was the SD-WAN interface.

An absolute SD-WAN rule was defined and matched traffic.

9. Refer to exhibits.

Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy

FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.

To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

10. Which three protocols are available only on the command line to configure as performance SLA status check? (Choose three.)

smtp

tcp-echo

twamp

udp-echo

icmp

Page 2 of 2

11. Refer to the exhibit.

Based on the exhibit, which two statements about traffic passing through the SD WAN member port2 are true? (Choose two)

FortiGate marks an existing session routing information as persistent

FortiGate, by default, resets all session routing information after a route change

FortiGate flushes all routing information from the session table after a route change

FortiGate performs new routing lookups for new packets after a route change

12. Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two)

FEC transmits the original payload in full to recover the error in transmission.

FEC improves reliability which overcomes adverse WAN conditions such as noisy links.

FEC is useful to increase speed at which traffic is routed through IPsec tunnels.

FEC transmits additional packets as redundant data to the remote device.

FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss

13. What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Per-IP shaping mode

Reverse policy shaping mode

Interface-based shaping mode

Shared policy shaping mode